Step 1 Quantar Repeater. b. Status Lights Check, Control Module. Quantar Repeater Field Troubleshooting. Normal Indications: Station On—illuminated RX Fail –off Station Fail —off V.24 Modem—not used in this model Intcm/ACC D—off Control Ch—off RX 1 Active—off until appropriate signal is received, If you have just a codeplug from an enhanced station, you should just be able to configure it to your type of station and band. Program the station. When it resets the WL Fail and WL On lights will flicker for several minutes. This is the controller programming the wireline board.
1/30/2018 · Okay. Drilling through my notes from the last Quantar system I put on the air in 2011, I used the following – everything connects to J17, the 25pr amphenol connector on the back – cable runs to a 66 block so I could do crossconnects to other equipment. rx tip J17-2 rx ring J17-27 tx tip J17-10 tx ring J17-35 cor out J17-43 (RDSTAT) ptt in J17-47, 12/14/2019 · Quantar power supply fail issue Good Afternoon, I have an interesting problem I ran into today. I helped a fire department replace there battery backup stack today, it had been dead for quite some time. After swapping out the batteries, i verified that that stack was putting out 26.48 volts before I turned the charger back on. Once the charger …
5/27/2020 · I do believe my SCM Module is a EPIC II card, requiring a EPIC II WL Card, but finding this ‘CLN6883B information turns up a dead-end. Just trying to get my AllStar node to key the Quantar and pass audio and COS and the like for basic repeater operation.
9/2/2013 · Incidentally, the WL light flashing green for a moment is a restart of the WLB. The system recognizes it’s not working so it reboots the card. One little detail I noticed when I had the 7477 WLBs w/ old firmware installed with the SCM running the new firmware: If the Quantar is transmitting, you’ll actually see the transmitter wander off …
10/9/2015 · Friend and I are trying to set up a Quantar 900 for amateur band and having some issues. Started up fine last week, used the RSS to set frequencies (927.525-, 88.5PL), and it worked fine for several days. Went to swop the PA module to test the spare, and blew dust out of the chassis and other modules. I removed the reference oscillator module, power supply, and PA, the other modules were.
5/16/2020 · Quantar Programing. The Quantar must be programed for several channels correctly, as the wildcard functions cause the system to chanel change depending on state. Essentially there is a mixed-mode channel and after a period of time, the system will move to an analog only or digital only channel.
NOTE: When a Quantar or ASTRO-TAC receiver is used in a voting system with MICOR or SPECTRA-TAC receivers, the HI boost value needs to be incremented by 1.5 dB in order to further equalize the Quantar or ASTRO-TAC receiver so that voting across all receivers will be equal.
