CLI Statement. EX Series,QFX Series. Configure the hashing key used to hash link aggregation group (LAG) and equal-cost multipath (ECMP) traffic, or enable adaptive load balancing (ALB) in a Virtual Chassis Fabric (VCF).
CLI Statement. EX Series,QFX Series. Select the payload fields in IPv4 traffic used by the hashing algorithm to make hashing decisions.
CLI Statement. MX Series,M Series,T Series,PTX Series. Select which packet header data to use for per-flow load balancing.
26 rows · CLI Command. EX Series,QFX Series. Display information about which packet fields are.
MX Series. MX MPC and T-Series Type 5 FPC Specifics, Hashing Algorithm Used in Junos 18.3R1 and later, Hash fields used for GRE traffic sent over IPv4 , Hash fields used for GRE traffic sent over IPv6, Hash fields used for IPv4 , Hash fields used for IPv6 , Hash fields used for multiservice, Hash fields used for MPLS, Junos 18.3 and later, Hash fields used for MPLS from Junos 14.1 to Junos 18 …
10/22/2012 · enhanced- hash -key = MPC (which works on the MX80 as it’s based on Trio) … > juniper -nsp mailing list juniper -nsp@puck.nether.net >https: … with MX TRIO you don’t need to configure anything to achieve almost the behaviour you need (almost = not per packet, read below).
1/ hash-key on MX is applicable only to DPC linecards and has no effect for MPC linecards. MPC linecards use enhanced- hash -key which has L3 and L4 loadbalancing enabled by default. 2/, 6/9/2020 · Steps to set load balancing by source IP only configuration: Without setting the ‘source-destination-only-loadbalancing’ knob, load balancing is expected to occur as below:. Note: In this example, ssh and telnet is used. Two different protocols accessing via remote device, which ensures the Source IP is the same and the Port is different.
